Dipon / art / craft / 5 cm
Product card with pour depth, curing time, mix ratio and practical workshop guidance from the NeuroResin database.
LuminaCast 8 Table Flow by Dipon is a deep cast epoxy resin for art / craft work, with a maximum working layer of 5 cm. The database records a 2:1 mix ratio, working time around 3 h (180 min), transparency described as crystal clear, UV resistance: medium and viscosity: low (~500 mPas). Full cure is listed as 5 days (120 h), so mechanical work should be planned with a safety margin rather than only around demolding time.
For LuminaCast 8 Table Flow, the key is calm setup and process control. Work at a stable temperature around 18-24C; in colder conditions this resin may cure more slowly, turn cloudy or remain soft on the surface. Keep the 2:1 ratio and mix slowly but thoroughly; with this resin class, poor mixing causes problems more often than the product itself. For wood and porous substrates, apply a seal coat before the main pour. The 5 cm layer limit should not be treated as extra safety margin when the mass is high, the mold is closed or the workshop is warm. Use the two-cup method: after the first mix, transfer into a second cup and mix again to reduce streaks and soft spots from the cup walls.
LuminaCast 8 Table Flow is best treated as a product for projects where the layer limit, patient degassing and full cure time of 5 days (120 h) matter. Choose a finish according to exposure, abrasion and expected sheen. Before the final pour, make a small sample using the target wood, pigment and workshop temperature.
The NeuroResin database lists the maximum working layer as 5 cm. For larger masses, warmer workshops or closed molds, keep a safety margin.
The listed working time is about 3 h (180 min). It depends on temperature, mixed mass and pour geometry.
Full cure is listed as 5 days (120 h). Demolding may be possible earlier, around 2 days (48 h), but machining is best planned after full cure.
The link comes from the current NeuroResin resin database record.
This resin product card is generated from NeuroResin product parameters and working notes. Always verify the current manufacturer TDS/SDS before production.