EcoPoxy / deep pour / 3.8 cm

FlowCast (Deep Pour 3.8cm / layered)

Product card with pour depth, curing time, mix ratio and practical workshop guidance from the NeuroResin database.

water clear (crystal clear cure) deep cast dobra (UV stabilizers, but not for outdoor use) ratio 100:43

About the product

FlowCast (Deep Pour 3.8cm / layered) by EcoPoxy is a deep cast epoxy resin for deep pour work, with a maximum working layer of 3.8 cm. The database records a 100:43 mix ratio, working time around 8 h (480 min), transparency described as water clear (crystal clear cure), UV resistance: dobra (UV stabilizers, but not for outdoor use) and viscosity: low (excellent air release). Full cure is listed as 14 days (336 h), so mechanical work should be planned with a safety margin rather than only around demolding time.

Working with it

For FlowCast (Deep Pour 3.8cm / layered), the key is calm setup and process control. Work at a stable temperature around 20-25C; in colder conditions this resin may cure more slowly, turn cloudy or remain soft on the surface. Keep the 100:43 ratio and mix slowly but thoroughly; with this resin class, poor mixing causes problems more often than the product itself. Wymagany seal coat — FlowCast wchodzi w pory drewna. Zalecany UVPoxy jako seal coat. The 3.8 cm layer limit should not be treated as extra safety margin when the mass is high, the mold is closed or the workshop is warm. Use the two-cup method: after the first mix, transfer into a second cup and mix again to reduce streaks and soft spots from the cup walls.

Summary

FlowCast (Deep Pour 3.8cm / layered) is best treated as a product for projects where the layer limit, patient degassing and full cure time of 14 days (336 h) matter. Choose a finish according to exposure, abrasion and expected sheen. Before the final pour, make a small sample using the target wood, pigment and workshop temperature.

Database parameters

Classdeep cast

Ratio100:43

Demold3 days (72 h)

Full cure14 days (336 h)

Working tips

Work at a stable temperature around 20-25C; in colder conditions this resin may cure more slowly, turn cloudy or remain soft on the surface.

Keep the 100:43 ratio and mix slowly but thoroughly; with this resin class, poor mixing causes problems more often than the product itself.

Use the two-cup method: after the first mix, transfer into a second cup and mix again to reduce streaks and soft spots from the cup walls.

Product FAQ

What is the maximum layer for EcoPoxy FlowCast (Deep Pour 3.8cm / layered)?

The NeuroResin database lists the maximum working layer as 3.8 cm. For larger masses, warmer workshops or closed molds, keep a safety margin.

What is the working time of EcoPoxy FlowCast (Deep Pour 3.8cm / layered)?

The listed working time is about 8 h (480 min). It depends on temperature, mixed mass and pour geometry.

When does EcoPoxy FlowCast (Deep Pour 3.8cm / layered) reach full cure?

Full cure is listed as 14 days (336 h). Demolding may be possible earlier, around 3 days (72 h), but machining is best planned after full cure.

Purchase

This resin record does not currently include a public purchase link.

Back to resin database

This resin product card is generated from NeuroResin product parameters and working notes. Always verify the current manufacturer TDS/SDS before production.